Is there a single variable for texture flashing w/ UsePools=0?

[Noel 4,527]

Howdy,Thanks to Bejote and others FSX is virtual perfection. Fairly rarely, I'll get a single white flashed texture. Almost not worth discussing . . . but I'm wondering which particular variable might be most likely involved. If the answer is a massive overview of all variables then I'll probably leave it be, but if someone knows with any certainly where to look without a major reconfigure it would be great to hear.Thanks in advance!Noel

[bojote 20]

Howdy,Thanks to Bejote and others FSX is virtual perfection. Fairly rarely, I'll get a single white flashed texture. Almost not worth discussing . . . but I'm wondering which particular variable might be most likely involved. If the answer is a massive overview of all variables then I'll probably leave it be, but if someone knows with any certainly where to look without a major reconfigure it would be great to hear.Thanks in advance!Noel

Hi Noel,sure.. it was discussed! ;) it was 'Water' it need to be se to HIGH 2.0 (not MAX 2.0) HIGH 2.0 double check. and check the long BP thread for the explanation... its related to shaders, two passes, CPU, draw calls etc etc..

[Guest firehawk44]

Howdy,Thanks to Bejote and others FSX is virtual perfection. Fairly rarely, I'll get a single white flashed texture. Almost not worth discussing . . . but I'm wondering which particular variable might be most likely involved. If the answer is a massive overview of all variables then I'll probably leave it be, but if someone knows with any certainly where to look without a major reconfigure it would be great to hear.Thanks in advance!Noel

There is also the known bug that causes occasional white flashes and that is with "Display Flying Tips" enabled in the realism section of the FSX settings. This box should be unchecked (default is checked).Best regards,Jim

[Noel 4,527]

There is also the known bug that causes occasional white flashes and that is with "Display Flying Tips" enabled in the realism section of the FSX settings. This box should be unchecked (default is checked).Best regards,Jim

Thanks to both of you I'll look at those . . .Noel

[newtie 537]

I wish I knew about this sooner. I gave up on the BP=0 for this very reason. I'm out of town until next week so I'll giver another try when I get back.Thanks

[Steve1969 8]

If you have two graphics cards, try enabling SLI. This stopped spiking and texture flashing for me when using BP=0